Braun 390cc Manuel D'utilisation page 9

electronics will then assume it has been
cleaned manually and a new calculation of
the time when the next cleaning is required
will be started. During the cleaning process in
the Clean&Renew™ the yellow light will flash
and will go off after approx. 4 hours when
cleaning is finished.
Automatic cleaning
Once the shaver is put into the
Clean&Renew™, it is cleaned auto-
matically (see separate instructions). Manual
cleaning is recommended only when the
Clean&Renew™ is not available, e. g. when
travelling.
Manual cleaning
The hand-held unit should be detached from
the power supply cord before cleaning. The
shaver should not be used until it has dried.
Regular cleaning ensures better shaving
performance. Rinsing the shaver head under
running water after each shave is an easy
and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse
the shaver head under hot running water.
You may use liquid soap without abrasive
substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next, switch off the shaver, remove the
shaver Foil & Cutter cassette (1) and let it
dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil onto the long hair trimmer
(2) and shaver Foil & Cutter cassette (1).
Alternatively, you may clean the shaver using
a brush:
• Switch off the shaver. Remove the shaver
Foil & Cutter cassette and tap it out on a
flat surface.
• Using a brush, clean the inner area of the
shaver head. However, do not clean the
shaver Foil & Cutter cassette with a brush
as this may damage it.
All manuals and user guides at all-guides.com
Replacement light for shaving parts/Reset
To maintain 100% shaving performance,
replace the shaver Foil & Cutter cassette (1),
when the replacement light for shaving parts
(8) comes on (after about 18 months) or when
worn.
The replacement light will remind you during
the next 7 shaves to replace the foil and
cutter cassette. Then the shaver will auto-
matically reset.
After you have replaced the Foil & Cutter
cassette (1), press the on/off switch (4) for at
least 5 seconds to reset the counter.
While doing so, the replacement light blinks
and goes off when the reset is complete. The
manual reset can be done at any time.
Preserving the batteries
In order to maintain the optimum capacity
of the rechargeable batteries, the shaver
has to be fully discharged (by shaving) every
6 months approximately. Then recharge the
shaver to full capacity.
Environmental notice
This appliance contains rechargeable
batteries. To protect the environment,
do not dispose of the appliance in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Center or appropriate collection sites.
C Clean&Renew™
Braun Clean&Renew™ has been developed
for cleaning, charging and storing your shaver.
Clean your shaver daily in the Clean&Renew™.
During the automated cleaning process, the
shaver is switched on and off at intervals
to obtain best cleaning results. Since the
specially formulated cleaning fluid contains a
small amount of oil, the cleaning procedure
also fulfils the lubrication needs of the shaver.
9