Beko TBN6602W Manuel D'utilisation page 9

4 Information
4.1 Tips for blending
• To add ice cubes to mixtures while the blender
is operating, add one cube at a time through the
cap (1). Wait a few seconds before adding the
next ice cube so that the blender can properly
blend the ice.
• To add food while the blender is operating,
remove the cap (1) and drop the ingredients
through the opening. Be sure to cut the food
into about 2-5 cm pieces to fit through the
opening. Replace the cap (1) when you have
finished adding ingredients.
• When blending solid food, such as raw
vegetables, cooked or uncooked meat and
fruits always cut them into no larger than 2-5
cm pieces before placing them into the glass jug.
Blend no more than 2 cups of these food at a
time. This will speed the blending process and
reduce wear on the blending blades.
• Always place liquid ingredients in the glass
jug first, unless a recipe specifically states
otherwise.
• To blend beverages, place all ingredients in the
glass jug at the same time.
• Avoid overblending. Usually, you will need to
blend for a few seconds.
• Overblending may cause food to become mushy.
4.2 Cleaning and care
WARNING: Never use petrol
A
solvents, abrasive cleaners, metal
objects or hard brushes to clean the
appliance.
WARNING: The blades of the
A
cutter unit are very sharp! Handle
the blades with utmost care in order
to avoid injuries.
A
WARNING: Never clean the
appliance with your bare hands.
Jug Blender Standmixer / User Manual
All manuals and user guides at all-guides.com
A
A
1. Turn the appliance off and disconnect it from
2. Allow the appliance to cool down.
3. Remove the glass jug D from the motor housing
C
4. Turn the glass container over and place it on a
5. To place the blade unit (6) back to the glass
6. Replace the glass jug (4) on the motor
7. Place 1 to 1 ½ cups warm water with some
WARNING: Clean the jug blender
after each use. Do not let any food
remnants harden on and inside the
jug blender. This will make it more
difficult to clean it later.
WARNING: Do not use boiling
water. The blade assembly bearings
have been designed with a lifetime
lubricant; exposure to boiling water
may damage these bearings and
shorten the life of the blender.
wall socket.
(8). Rinse with water to remove any large food
particles that may have accumulated in the
glass jug.
You can use the measuring cup (1) to
remove the blender blade.
level, non-slip surface. Attach the measuring
cup (1) by placing it over the cutting blade unit
(6). Remove the cutting blade unit (6) by turning
it with the measuring cup in the direction of the
"open lock symbol" (counterclockwise). Glass
container, lid and measuring cup can now be
washed in the dishwasher. Carefully rinse the
cutting blade unit under running water.
container (4), turn the blade unit (6) to the
locking " " direction (clockwise) using the
measuring cup (1).
housing (8).
drops of mild cleanser into the glass jug (4) and
switch to speed "4" for a few seconds. Remove
the glass jug from the motor housing and rinse
with water. Repeat as necessary.
9 / 64 EN