Beko TBN6602W Manuel D'utilisation page 8

3 Operation
A
WARNING: Never let the jug
blender operate without the glass
jug on the motor housing.
5. Close the lid (3). Make sure that the cap/
measuring cup (1) is inside the lid opening and
is secured.
6. Place the glass jug (4) upright onto the motor
housing (8).
A
WARNING: Never move or turn
the glass jug after it is properly
seated in the place.
7. Connect the power plug to a suitable power
outlet.
8. The cutting speed can be variably adjusted with
the control dial (9).
C
To operate the blender at the low
speed, turn the control dial (9) to "1".
C
If you want to blend with a higher
speed, turn the control dial (9) to the
desired speed level (2-4).
For short pulses of blending with a
C
high speed, turn the control dial (9)
to "P". When you release the control
dial (9), the blender will stop and
return to "0" automatically.
If ingredients are to be added during
C
the blending process, then add them
through the opening in the lid (2). To
do this, take out the cap/measuring
cup (1).
9. After the desired consistency of the blended
food has been reached, turn the control dial (9)
to 0 to switch off the blender
A
WARNING: Never run the blender
for longer than 1 minute, otherwise
it would overheat.
8 / 64 EN
All manuals and user guides at all-guides.com
A
A
A
10. Pull the power plug out of the power outlet.
11. Take the glass jug (4) off from the motor
12. Take off the lid and pour the mixture into
WARNING: After running the
appliance for 1 minute, let it cool
down before using it again.
WARNING: Be sure the motor
is switched off and has completely
stopped before removing the glass
jug (4) from the motor housing (8).
WARNING: Do not place any
utensil (scraper, fork, etc.) in the
glass jug while blender is operating.
housing (8) by lifting the glass jug upwards
(do not try to rotate it) and open the lid (3).
glasses or other containers.
Jug Blender Standmixer / User Manual