Toro Flex-Force Power System 60V MAX Manuel D'instructions page 11

2
Assembling the Handle
Parts needed for this procedure:
1 Upper handle assembly
2 Bolt
2 Locknut
Procedure
Important:
Remove and discard the protective
plastic sheet that covers the mower and any other
plastic or wrapping on the machine.
Note:
Remove the rubber end-cap from the handle
assembly prior to inserting the upper handle bar
into the lower handle bar. These are added during
manufacturing to prevent damage to the cables.
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Install the upper handle assembly to the lower
handle and secure it using 2 bolts and 2 locknuts
as shown in Figure 4.
Figure 4
2. Pull the handlebar release brace toward the
upper handle to release the handle lock
5).
3. Move the handle rearward to the operating
position and let go of the handlebar release
brace (Figure
Note:
Ensure that the handle clicks into place.
g342173
9
5).
Figure 5
(Figure
g341335