Publicité
Les langues disponibles
Les langues disponibles
Basic Operation
UPS ON/OFF
• Plug the UPS into a grounded outlet.
• Turn the UPS on: Press and hold the
beep once briefly after 2 seconds have passed.
• Plug equipment into the UPS: Select outlets will provide battery backup and surge
protection; connect your computer, monitor and other critical devices here.* Select
outlets will provide surge protection only; connect your printer and other nonessential
devices here.
• Turn the UPS off: Press and hold the
beep once after 2.5 seconds have passed.
* Your UPS is designed to support electronic equipment only. You will overload the UPS if the total
VA ratings for all the equipment you connect to the "Battery, Surge and Noise Protected" outlets
exceeds the UPS's Output Capacity. To estimate your equipment's power requirements, look
on the nameplates. If the equipment is listed in amps, multiply the number of amps by 120 to
determine VA, (Example: 1 amp x 120 = 120 VA). Your UPS is fully loaded when the display
indicates 100% load.
LCD Features
Tap the
button to advance from one display to the next. Use the
settings for ECO, Alarm, LCD Brightness and Self-test functions. When the preferred
setting has been selected, continue by pressing the
20 seconds, the LCD will return to the home screen, retaining the last selected settings.
Display Power Conditions
Use the
button to advance through power conditions.
• Voltage In
• Voltage Out
• Estimated Runtime (in minutes)
• Load %*
• Load Wattage*
• Battery Capacity %
* Display measurement represents battery backup protected outlets only.
ECO Energy-Saving Feature
Use the included USB cable to connect your UPS to your computer. Connect
nonessential equipment to the ECO outlets, marked "ECO" on your UPS system. Make
sure that any devices connected to the ECO outlets can be turned off without interrupting
your Internet connection, local network, or other essential services. While your UPS is
turned on and operating normally from utility power, tap the
advance the LCD display to the screen marked "ECO". Use the
ECO function.
17-05-138-933071.indb 4
button for 2 seconds. The UPS alarm will
button for 2.5 seconds. The UPS alarm will
button. If the screen is idle for
button repeatedly to
4
button to toggle
button to enable the
6/2/2017 11:44:26 AM
Publicité
