LEGRAND Wiremold OFR Serie Instructions D'installation page 3

Vista Point5 Transition Fitting (OFR-VL)
1. Remove lower access panel from Vista Point5.
3. Use a razor knife to remove the edge of the plastic boot
across the opening where the ccess Panel was.
Cut Boot away
in this area
5. Insert Transition Fitting connecting tabs into outer
channels of raceway base mounted to floor. Tighten
two (2) #8-32 screws to secure.
2. Remove conduit adapter plates from base of Vista Point5.
4. ttach Transition Fitting base to base of Vista Point5 using
(2) #8-32 round head screws. Vista Point5 divider must be
oriented as shown.
6. ttach Divider to Transition Fitting base.
3