Kenwood DDX6706S Guide De Démarrage Rapide page 19

• This unit has the cooling fan to decrease the
internal temperature. Do not mount the unit
in a place where the cooling fan of the unit is
blocked. Blocking these openings will inhibit
the cooling of the internal temperature and
result in malfunction.
(DDX6906S/ DDX6706S/ DDX5706S)
Cooling fan
(DMX706S/ DMX7706S)
• Do not press hard on the panel surface when
installing the unit to the vehicle. Otherwise
scars, damage, or failure may result.
• Reception may drop if there are metal objects
near the Bluetooth antenna.
Bluetooth antenna unit
All manuals and user guides at all-guides.com
Cooling fan
Ñ
Supplied accessories for
installation
1
2
(3 m)
3
4
(M5 x 8 mm)
5
(M5 x 8 mm)
6
[1]
7
(2 m)
[1] DMX706S/ DMX7706S only
Ñ
Installation procedure
1) To prevent a short circuit, remove the key
from the ignition and disconnect the ¤
terminal of the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the speaker wires of the wiring
harness.
4) Connect the wiring harness wires in the
following order; ground, battery, ignition.
5) Connect the wiring harness connector to the
unit.
6) Install the unit in your car.
7) Reconnect the ¤ terminal of the battery.
8) Perform the Initial Setup.
See Initial setup (P.4).
x1
x1
x2
x6
x6
x1
x1
19
English