DJO AIRCAST AIRSELECT ELITE Mode D'emploi page 3

• To inflate other aircells, rotate SELECTOR to the appropriate number and then
press and release large inflation pump. Pump until aircell
feels snug. When all aircells are inflated, rotate SELECTOR to "lock" position.
• In the event of over-inflation, deflate aircells.
4) DEFLATE AIRCELLS –
• To deflate aircells, turn the SELECTOR found on the right-side of the brace to
the proper aircell number (Fig. D).
Press and hold finger on the small release button found on the top right-side of
•
brace (Fig. F).
• Deflate until pressure is comfortable.
NOTE: Deflate aircells before removing brace for proper fit when reapplying.
NOTE: Higher pressure provides more support when walking, lower
pressure is more comfortable when sitting or reclining. Pressure
can also be adjusted by tightening or loosening straps.
NOTE: The shell can be trimmed with a cast saw or cast scissors to accommodate
larger calves.
CLEANING INSTRUCTIONS:
THE FOAM LINER MAY BE HAND-WASHED IN 86°F/30°C WATER WITH MILD
DETERGENT AND AIR-DRIED. DO NOT PUT IN DRYER OR USE OTHER HEAT
SOURCE TO DRY.
WARRANTY:
DJO, LLC will repair or replace all or part of the unit and its accessories for material
or workmanship defects for a period of six months from the date of sale.
NOT MADE WITH NATURAL RUBBER LATEX.
INTENDED FOR USE ON A SINGLE PATIENT.
RX only.
MATERIAL COMPONENTS
Shell: POLYPROPYLENE
Front Panel: HIGH DENSITY POLYETHYLENE
Straps: NYLON
Lined Aircells (Anterior and Posterior): POLYURETHANE w/ POLYESTER FABRIC
Inflation Pumps: TPU (THERMOPLASTIC POLYURETHANE)
Liner: NYLON/POLYURETHANE/POLYESTER (OUTER/FOAM/INNER MESH)
Binding: POLYESTER
Outer Sole / Insole: EVA/RUBBER
Selector dial: NYLON
Sock (Elite): Polyester, Spandex
NOTICE: WHILE EVERY EFFORT HAS BEEN MADE IN STATE-OF-THE-ART TECHNIQUES TO OBTAIN
THE MAXIMUM COMPATIBILITY OF FUNCTION, STRENGTH, DURABILITY AND COMFORT, THERE IS NO
GUARANTEE THAT INJURY WILL BE PREVENTED THROUGH THE USE OF THIS PRODUCT .
3