Domo DO7048S Mode D'emploi page 26

DO7048S www.domo-elektro.be
Spraying
The spray button can be used at all times, with or without steam ironing, as long as the
water reservoir is filled up. When using the spray button for the first time press it in
repeatedly in order to activate it.
Steam shot
Through means of the steam shot you can remove tough creases.
Adjust the temperature dial to MAX (fig 3) and wait until
the indicator lamp goes out.
Press on the stem shot button. Wait a few seconds so the
steam penetrates the material before pressing again.
Please Note: Do not use the steam shot more than three
times in a row so that the best quality steam is achieved.
Repetitive use of the steam shot function will lower the
iron's heat. For this reason, always pay attention to the temperature indicator lamp
before and after using this function.
Anti-scale cleansing
The anti-scale cleansing system will greatly reduce the limescale build-up that can
occur during ironing. This will lengthen the lifespan of your iron considerably.
With prolonged use of your iron some limescale build-up is unavoidable.
Switching off automatically
In order to conserve energy and to guarantee your safety the iron will automatically
switch off when not in use for a certain amount of time. When you plug the appliance
in to the mains socket this function will not be active for the first 30 second because
the appliance must warm up.
After warming up the appliance will switch itself off if you do not use it for 8 minutes
while it has been placed in the vertical position resting on its back end. If you leave
your appliance for 30 seconds in a horizontal position without moving the safety
system will also switch the iron off. In order to use the iron again moving it lightly
back and forth will reactivate it.
ERROR MESSAGES AND SOLUTIONS
The iron does not warm up.
The temperature dial must be set to the correct temperature. Adjust the setting to a
higher temperature than MIN.
The iron fails to provide steam
The water reservoir is empty. Adjust the settings on the steam dial to '0' and add
water. Allow the iron enough time to warm up and readjust the temperature dial to the
position marked steam ironing (•••).
26