Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
D
B
Twin Halogen
®
ual
rite
Motion Sensing Light
Model SL-5512
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• D
B
Timer.
®
ual
rite
• Photocell keeps the lighting off during daylight
hours.
• LED indicates motion was sensed (day or night).
This package includes:
Plastic Hanger
Rubber Plug
Cover
Plate
Light Control
Mounting Bolt
Mounting Strap
2 Halogen Bulbs
Light Shield
© 2008 HeathCo LLC
All manuals and user guides at all-guides.com
6 Mounting
Screws (3 sizes)
3 Wire
Connectors
Sensor
Gasket
Requirements
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a
qualified electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
OPERATION
Mode:
On-Time
Test
5 Seconds
Auto
1, 5, or 20 Min
Manual
To Dawn*
Accent
3, 6 Hr, to Dawn
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
TEST
Put ON-TIME switch
on the sensor bottom
to TEST and the D
-
ual
B
switch OFF.
®
rite
AUTO
Put the ON-TIME switch in the 1, 5,
or 20 minute position.
MANUAL MODE
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 20
position.
Works: Day Night
x
x
x
x
x
/
minutes for
1
2
ON-TIME
D
B
ual
rite
TEST 1 5 20
Off 3 6 Dusk to
Dawn
ON-TIME
TEST 1 5 20
1 Second OFF
then...
... back on.
595-5575-09
®
Publicité
Manuels Connexes pour Heath Zenith DualBrite SL-5512
Sommaire des Matières pour Heath Zenith DualBrite SL-5512
- Page 1 All manuals and user guides at all-guides.com Requirements • The light control requires 120-volts AC. • If you want to use Manual Mode, the control must be Twin Halogen wired through a switch. ® rite • Some codes require installation by a Motion Sensing Light qualified electrician.
- Page 2 All manuals and user guides at all-guides.com INSTALLATION Mode Switching Summary TEST For easy installation, select an existing light operated Move ON-TIME Switch to by a wall switch for replacement. 1, 5, or 20 minutes For best performance, mount the fixture about 8 ft. (2.4 m) AUTO above the ground.
- Page 3 All manuals and user guides at all-guides.com Bulb Installation Mount the Light Control NOTE: Lamps are included, but you will need to install ❒ Place the mounting bolt through the front of the them junction box cover. Push the small gasket hole over NOTE: When re-lamping, turn power off and let the the mounting bolt.
- Page 4 All manuals and user guides at all-guides.com TEST AND ADJUSTMENT NOTE: If fixture is mounted higher than 8 ft. (2.4 m), aiming the sensor down will reduce coverage distance. ❒ Turn on the circuit breaker and light switch. The detector is less sensitive to motion directly towards it. NOTE: Sensor has a 1 minute warm up period before it will detect motion.
- Page 5 All manuals and user guides at all-guides.com SPECIFICATIONS Range ... . Up to 70 ft. (21 m); 100 ft. (30.5 m) with Range Boost. [var ies with surrounding temperature] Sensing Angle ..Up to 240° Electrical Load .
- Page 6 All manuals and user guides at all-guides.com TECHNICAL SERvICE Please call 1-800-858-8501 (English speaking only) for assistance before returning product to store. If you experience a problem, follow this guide. You may also want to visit our Web site at: www.hzsupport.com. If the problem persists, call* for assistance at 1-800-858-8501 (English speaking only), 7:30 AM to 4:30 PM CST (M-F).
- Page 7 All manuals and user guides at all-guides.com Requisitos • El control de luz requiere 120 VCA. • Para usar el Sobrecontrol Manual, conecte el control Luz halógena gemela con un interruptor. • Algunos códigos requieren instalación por un con detector de electricista calificado.
- Page 8 All manuals and user guides at all-guides.com INSTALACION Resumen de las modalidades del interruptor Para una fácil instalación escoja una luz con un PRUEBA interruptor de pared. Mueva el interruptor de tiempo (ON-TIME) a 1, 5 Para un mejor funcionamiento, instale el aparato a casi ó...
- Page 9 All manuals and user guides at all-guides.com Instalación de Bombilla Instale el Control de Luz NOTA: Incluye lámparas pero, usted deberá instalar- ❒ Ponga el perno de montaje a través del frente de las. la tapa de la caja de empalme. Empuje el agujero NOTA: Cuando cambie la bombilla, apague la energía pequeño de la empaquetadura sobre el tornillo de y deje que el aparato se enfríe.
- Page 10 All manuals and user guides at all-guides.com PRUEBA Y AJUSTE NOTA: Si el aparato está instalado a más de 8 pies (2,4 m), si se apunta el detector hacia abajo se reducirá la ❒ Prenda el cortacircuitos y el interruptor de luz. distancia de cobertura.
- Page 11 All manuals and user guides at all-guides.com ESPECIFICACIONES Retardo de Tiempo . . 1, 5, 20 minutos Lámpara de Alcance ... Hasta 21 m, Aumento de Dis- repuesto ... Halógena T3 de 150 vatios, máx. tancia prendido.
- Page 12 All manuals and user guides at all-guides.com SERvICIO TÉCNICO Favor de llamar al 1-800-858-8501 (sólo para hablar en inglés) para pedir ayuda antes de devolver el producto a la tienda. Si tiene algún problema, siga esta guía. Usted puede también visitar nuestro sitio Web: www.hzsupport.com. Si el problema continúa, llame al 1-800-858-8501 (sólo para hablar en inglés), de 7:30 AM a 4:30 PM CST (L- V).
- Page 13 All manuals and user guides at all-guides.com Exigences • La commande d’éclairage nécessite une alimentation de 120 V c.a. Luminaire halogène double • Pour utiliser la priorité manuelle, raccorder la com- mande à un interrupteur. à détecteur de mouvement • Certains codes de bâtiment locaux peuvent exi- ger que l’installation soit faite par un électricien rite qualifié.
- Page 14 All manuals and user guides at all-guides.com INSTALLATION Résumé du mode de commutation Pour faciliter l’installation, choisir un appareil d’éclairage TEST Placer l’interrupteur ON- devant être remplacé et qui est déjà commandé par un TIME à 1, 5 ou 20 minutes interrupteur.
- Page 15 All manuals and user guides at all-guides.com Installation De L’ampoule Montage de la Commande D’Éclairage NOTE: Les lampes ont été incluses, mais il vous faudra les installer. ❒ Insérer la vis de montage dans le trou du couvercle NOTE: Avant de remplacer une ampoule, couper l'ali- de la boîte de jonction.
- Page 16 All manuals and user guides at all-guides.com ESSAIS ET RÉGLAGES NOTE : Lorsque le luminaire est installé à une hauteur supérieure à 8 pi (2,4 m), le fait de diriger le détecteur ❒ Mettre en circuit le disjoncteur et l’interrupteur vers le bas réduit la portée de la couverture.
- Page 17 All manuals and user guides at all-guides.com FICHE TECHNIQUE Minuterie ..1, 5 ou 20 minutes ..Hors circuit, 3, 6 heures, crépus- rite Portée .
- Page 18 All manuals and user guides at all-guides.com SERvICE TECHNIQUE veuillez faire le 1 800 858-8501 (service en anglais seulement) pour obtenir de l’aide avant de retourner l’article au magasin. En cas de problème, suivez ce guide. Vous pouvez aussi visiter notre site Web à www.hzsupport.com. Si le problème persiste, composez* le 1 800 858-8501 (service en anglais seulement), entre 7 h 30 et 16 h 30, HNC, du lundi au vendredi.
- Page 19 All manuals and user guides at all-guides.com NOTE / NOTA _________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ _____________________________ 595-5575-09...
- Page 20 All manuals and user guides at all-guides.com Purchase Information Información de la compra Renseignements d’achat Model #: _________________ Date of Purchase: ______________ Nº de modelo / N° de modèle Fecha de compra / Date d’achat Staple Purchase Receipt Here Engrape aquí el recibo de compra Agrafez le reçu d’achat ici PLEASE KEEP YOUR DATED SALES RECEIPT, IT IS REQUIRED FOR ALL WARRANTY REQUESTS.