Safety Instructions For Maintenance - Husqvarna K 7000 Manuel D'utilisation

The transmission cover and the spray guard prevent
hand injury from the diamond chain during operation.
The spray guard and the rear handle prevent injury if the
diamond chain or pieces from the cut material are
thrown in the direction of the operator.
To examine the transmission cover, the spray
guard and the rear handle guard
WARNING: A damaged transmission cover,
spray guard or rear handle guard can cause
injury.
1. Make sure that the transmission cover, the spray
guard and the rear handle guard are attached
correctly and do not show signs of damage.
2. Make sure that the transmission cover, the spray
guard and the rear handle guard have no cracks or
are damaged.
3. Replace the transmission cover, the spray guard and
the rear handle guard if they are damaged.
Start and overload protection
The product has an electronically controlled start and
overload protection, Elgard
current immediately if the diamond chain does not move
freely.
10
™
. The electronics stop the
For explanation of the indication lamps, refer to the table
Lamp indicators in the product on page 17 .
in
Vibration damping system
Your product is equipped with a vibration damping
system that is designed to minimize vibration and make
operation easier. The product's vibration damping
system reduces the transfer of vibration between the
motor unit/cutting equipment and the product's handle
unit.
To do a check of the vibration damping
system
WARNING: Make sure that the motor is off
and that the power plug is disconnected.
1. Make sure that there are no cracks or deformation
on the vibration damping units. Replace the vibration
damping units if they are damaged.
2. Make sure that the vibration damping units are
correctly attached to the motor unit and handle unit.

Safety instructions for maintenance

WARNING: Read the warning instructions
that follow before you use the product.
• Make sure that the motor is off and that the power
plug is disconnected.
• Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
• Let an approved Husqvarna service agent do
servicing on the product regularly.
• Replace damaged, worn or broken parts.
• Always use original accessories.
1455 - 003 - 03.03.2020