Connection For Flush-Mountable Timer; Ascii Rs232 Or Rs422/485 Options; Emission Or Unidirectional Mode - Gorgy Timing LEDI 1.60 BOÎTIER PIVOTANT Mode D'emploi

☛
It is also possible to obtain an intermediate time by keeping one of the
☛
When a set time is programmed in either stopwatch or count-down
function, the timer may be stopped and restarted at any moment by pressing
on the "STOP" and " START" buttons, without modifying the set time initially
☛
It is possible to trip a dry contact at zero seconds with the pip option

5.1.3. Connection for flush-mountable timer

Timer Sub.D 9 way connector pin out :
► Pin1 : PROG
► Pin2 : +
► Pin3 : -
► Pin4 : Switch clock / chrono
► Pin5 : Gnd

5.2. ASCII RS232 OR RS422/485 OPTIONS

ASCII RS232C link to terminal B3
1: GND
2: TXD
3: RXD
THIS OPTION OPERATES IN 3 MODES

5.2.2. Emission or unidirectional mode

In this mode the clock emits a code (configuration: 2400 bauds, format 8 bits, even
parity, 1 stop bit) in 2 parts:
► 1) – The time information as follows:
STX day of the week SP day of the month/month/year SP SP Hour:minute:second CR
► 2) – The information on the status of the chronometer, temperature, luminosity, etc...
The first part of this information is used for example to synchronise a computer (in this
case don't take into account the second part).
The complete information is used to slave another clock to the first one.
26
"LAPS" buttons on the timer pressed.
programmed.
(consult us).
1
ASCII RS422/485 link to terminal B3
1: E/S -
2: E/S +
3: GND
MDE-LEDI160S-1012V1.0