Télécharger Imprimer la page

AstroStart 2504A Manuel De L'usager page 37

Publicité

Les langues disponibles

Les langues disponibles

OTHER COMMANDS
ANTITHEFT (CIRCUIT DISABLER)
Programmable as Active or Inactive during installation.
Your Remote Starter is equipped with an Antitheft system. This system consists of an output that controls a relay that cuts all
circuits required to operate your vehicle (optional connection).
"P
A
»
A
ASSIVE
RMING
TYPE
NTITHEFT
This type of Antitheft system arms automatically when ignition key is turned from RUN to OFF and remains OFF for one
minute. It can also be armed manually by sending a "Lock" command (unless ignition key is in RUN position).
D
:
ISARMING
Antitheft system is disarmed for one minute when you send "Unlock" command.
If ignition key is not turned to 'RUN' position within one minute, system automatically rearms, thus preventing an intruder
from starting your vehicle, even with ignition key. The indicator light (optional) blinks rapidly during rearming, and then
continuously when antitheft system is armed.
It can be connected so that horn sounds if an intruder tries to start your vehicle when it is in the active state.
"A
»
A
CTIVE
TYPE
NTITHEFT
This type of antitheft system is armed by sending a 'Lock' command (unless ignition key is in 'RUN' position) and is
disarmed by sending an 'Unlock' command. The indicator light (optional) blinks continuously when antitheft system is armed
V
M
(A
)
ALET
ODE
NTITHEFT
The antitheft function can be deactivated for the same reasons and in the same way as the Antitheft system. See "Valet
mode" details on page 15.
INDICATOR LIGHT
An optional indicator light (LED) can be added to the system to show the status of the safety sequence (on vehicles
equipped with a manual transmission), and the status of the safety system, the antitheft system or the Valet Mode.
See 'Indicator Light' in the 'Safety System' Section.
The following table shows the codes displayed by the indicator light when performing the safety sequence.
Repeated flashes
Phase or Status
3 double flashes
Start of sequence.
2 double flashes
Door open.
1 double flash
Door closed (waiting for engine to stop).
1 single flash
Valid safety sequence (system is ready to receive a start command).
Fast (10 sec.)
Invalid sequence (sequence must be started over from beginning).
UTILITY COMMANDS
These commands allows you to control most of the vehicle accessories depending on what was connected during
installation (headlights, defroster, etc.). For more information, check with your technician.
Refer to the table of command on page 5 to know which button to
Commands
Corresponding accessories
UTILITY 1 *
UTILITY 2
UTILITY 3
UTILITY 4
The accessory associated to each of these commands is activated for the duration set at the installation.
The delay can be cancelled by repeating the command.
* Programmable during installation : The "trunk" command can access the "utility 1" function.
Duration
15

Publicité

loading

Ce manuel est également adapté pour:

J5f-tx60a