Publicité
Les langues disponibles
Les langues disponibles
CONTINUOUS MODE
Continuous Mode function lets you remove the key from the ignition while leaving the engine running. This convenient
feature allows you to leave your vehicle for short periods while climate controls remain on.
To access Continuous Mode, press on the
on page 6). If Turbo Mode is active, you must press a second time on the
A
ENGINE
UTOMATIC
remote to set the runtime according to the preset settings.
TRANSMISSION
VEHICLES
Parking lights, engine and climate controls will remain on for the duration of the programmed
runtime.
To access Continuous Mode, press on the
performing the safety sequence described on page 3. See "STARTING the ENGINE" on page 6.
M
ANUAL
Note: Do not send the stop command
TRANSMISSION
(Step 7) on page 3.
VEHICLES
If Turbo Mode is on, it will be activated when the safety sequence is executed.
Remove the key, exit vehicle and lock all doors. All safety devices will remain active.
If you return to your vehicle before runtime has elapsed, just turn the key to RUN position and press the brake pedal.
TURBO MODE
(Activated at time of installation)
This mode allows the engine to be left running at idle speed for a short period of time so that the turbocharger can cool down
as recommended by certain car manufacturers.
This mode activates the continuous mode at a reduced runtime (one or two minutes according to the programming).
To activate the Turbo Mode, press on the
(2 sec.) button (refer to 'Continuous Mode').
W
HAT STOPS THE ENGINE
For your safety, engine will not start or will stop if:
Your key is in the RUN position (prevents Start cycle).
Remote control sends a Stop message.
Hood is open.
Brakes are applied.
Engine is over-revving (if programmed Enable at installation).
Alarm detects intrusion.
Main switch is OFF.
Safety sequence not valid (manual transmission vehicle only - parking brake not applied, opening of door detected
while remote starter was not keeping engine running).
M
AIN SWITCH
Main switch is usually mounted under dashboard. It is a toggle ON/OFF
switch that is used to cancel start functions.
It does not disable other commands which remain active (alarm, lock/unlock
commands, etc.).
STOP
Refer to the table of command on page 5 to know which button to press.
This command only applies when engine is kept running by Remote Starter.
It is used to stop the run time, the panic mode as well as the alarm condition without disarming the security system.
button while engine is idling (see S
TARTING THE
button of the
button before removing the key from ignition when
if you perform sequence activated by the remote control
7
Publicité
