Shampooing/Cleaning; Spraying/Disinfection - Birchmeier Foam Cleaner 20 Mode D'emploi

Warning:
Chemical reaction hazard!
Unit must be thoroughly cleaned of all residue before switching from acid
to alkaline cleaning agents! Pressure vessel will otherwise be damaged by
pitting.
 Flushing pressure vessel (refer to flushing pressure vessel)
Note:
Pressure = 5,5 bar:
Compressor cuts out
Pressure = 4 bar:
Compressor cuts in again

Shampooing/cleaning

 Mounting shampoo nozzle (pre-assembled, part of scope of delivery)
 Open air supply valve (position in direction of flow)
24
Give control valve 2,5 anti-clockwise turns.
Set ONN/OFF switch to „I".
Allow operating pressure to build up (compressor cuts out).
Actuate hand gun.
Note:
Set shampooing mode at control valve:
Turning anti-clockwise = Shampoo becomes moister
Turning clockwise = Shampoo becomes drier
Tip:
A longer exposure time makes severe, stubborn soiling easier to remove.
This applies particularly to cleaning of exhaust air ducts, corners and
awkwardly shaped surfaces.

Spraying/disinfection

 Mounting fan-jet nozzle (accessory, not part of scope of delivery)
Mount nozzle
 Stopping machine
 Dissipate pressure
 Fit nozzle with cap nut