Pfannenberg DTS 6201C Instructions D'utilisation page 67

GB
4.3 Service interface
•
The service interface (1) can be used to change operating parameters.
•
For this purpose, a USB adapter (2) and the ECoolPLANT 2.X configuration software and USB driver software
are required.
•
The connection for the USB adapter is marked on the electrical circuit diagram with the identifier X28.
•
The USB adapter enables connection to a computer that works with the ECoolPLANT 2.X configuration
software. The detailed use is described in the corresponding operating manual for the ECoolPLANT 2.X
software.
•
Remove the USB adapter (2) from the unit after use. The service interface (1) is only provided for temporary
data exchange in order to read system notifications, etc. Continuous operation is prohibited.
 The USB adapter is available as an accessory, see
 The ECoolPLANT software (3) is available for download free of charge on the website:
https://www.pfannenberg.com/
 The corresponding operating manual for the ECoolPLANT software is available
Pfannenberg.
Operating Manual DTS and DTI 6201C / 6301C Standard Controller (SC) 086100015c © Pfannenberg GmbH
3
2
Figure 22 – Service
QR-Code (3).
1
interface
Spare part orders.
HERE and from My
Page 28 / 39