6
Lighting Instructions
EN
WARNING!
WARNING!
valve.
2. Push and turn any main burner knob slowly to the
'hi' position. This action will ignite the pilot flame
which will in turn light the selected burner. If the pilot
lights, continue to push down on the control knob until
3. If the pilot does not ignite, then immediately turn
the control knob back to the 'off position and repeat
4. If the pilot and burner will not ignite within 5
seconds, turn the control knob to the 'off' position and
wait 5 minutes for any excess gas to dissipate. Either
5. If lighting the unit with a match, clip the match into
the supplied lighting rod. Hold the lit match down
through the grill and sear plate while turning the
WARNING!
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
www.napoleongrills.com
Left
Burner
Open lid.
Ensure all burner controls are in the off position. Turn on the gas supply
Main Tube Burner
Lighting
1. Open grill lid.
the burner lights and then release.
step 2 several times.
repeat steps 2 and 3 or light with a match.
corresponding burner valve to high.
The propane cylinder is equipped with an excess flow device. Unless all burners are
Do not use the rear burner (rotisserie burner) with the main burners operating.
Side Burner
Right
Burner
Off Position
Side Burner Lighting
1. Open side burner cover.
2. Push and turn the side burner control knob slowly to
the 'hi' position. This action will ignite the side burner
3. If the burner does not ignite, then immediately turn
the control knob back to the 'off' position and repeat
step 2 several times.
4. If the burner will not ignite within 5 seconds, turn the
side burner control knob to the 'off' position and wait
5 minutes for any excess gas to dissipate. Either repeat
steps 2 and 3 or light with a match.
N415-0401 FEB 20.18