MeisterCraft MAS 180 Li-Ion Traduction Du Manuel D'utilisation Original page 46

5451370-Akku-Bohrs-man 30.01.14 07:12 Seite 46
• Before laying the stick screwdriver
aside, ensure that all moving parts
have come to a standstill.
• Avoid frequent blocking when drilling,
tightening or loosening screws.
• Connect the charger only to a
100–240 V AC power supply.
• Charge the screwdriver battery only
with the charger supplied.
• Protect the charger and the
screwdriver from contact with
moisture. Never immerse in water!
• Do not use the charger in the open air.
• To avoid damage to the batteries,
never expose them to temperatures of
over 50 °C.
CAUTION! Do not short-circuit the
contacts of the battery or charger.
• When charging, ensure that the
device is correctly connected („+/–").
• Do not attempt to burn the battery.
• The connection cord cannot be
replaced. In case of damage, dispose
of the device in the correct manner. In
case of damage, dispose of the
device in the correct manner.
7 – Charging battery
This battery-powered screwdriver
MAS 180 Li-Ion may only be
charged using the JLH082250370G
mains adapter unit. The mains adapter
unit may only be operated with a
power supply that has an alternating
current of 100–240 V~ and a frequency
46
of 50–60 Hz. The use of any other
mains adapter units or the use of the
JLH082250370G with another type of
power supply may lead to personal and
property damage.
Lithium-ion battery technology
This new type of battery has decisive
advantages over conventional Ni-Cd
batteries:
• No memory effect, i.e. regardless of
its charge status the battery can be
recharged at any time before or after
use without loss of capacity.
• Extremely low self-discharge, so it is
ready for use even after longer storage
periods.
• Light in weight
• Long service life
Removing the battery from or
inserting the battery into the power
tool
Press the unlocking button (9) on the
battery (5). Pull the battery forwards out
of the power tool (Figure 2). To insert
the battery, follow the steps in reverse
order until you hear it click into place.
Putting the rechargeable battery into
and removing it from the charging
station
Slide the charging station (6) in
accordance with Figure 3 onto the battery
until you hear it click into place. To
remove, press the unlocking button (9) on
the battery and pull the charging station.
Charging process (Figure 3)
CAUTION! The rechargeable
battery is not fully charged on