Bosch KGN56 Serie Manuel D'utilisation page 23

10.2 Setting up Home Con-
nect
Requirements
¡ The Home Connect app has been
installed on your mobile device.
¡ The appliance is receiving signals
from the WLAN home network (Wi-
Fi) at its installation location.
Open the Home Connect app and
1.
scan the following QR code.
Follow the instructions in the
2.
Home Connect app.
10.3 Switching on the con-
nection to the WLAN
home network (Wi-Fi)
Press .
▶
10.4 Switching off the con-
nection to the WLAN
home network (Wi-Fi)
Press .
▶
10.5 Installing updates for the
Home Connect software
Note: If an update of the Home Con-
nect software is available, a message
appears in the Home Connect app.
To install the update for the
▶
Home Connect software, follow the
instructions in the Home Connect
app.
a The control panel is partially
locked during the installation.
10.6 Resetting Home Connect
settings
If your appliance experiences con-
nection problems with the WLAN
home network (Wi-Fi) or your appli-
ance wants to log into a different
WLAN home network (Wi-Fi), you can
reset the Home Connect settings.
Press and hold
▶
until goes out.
a The Home Connect settings have
been reset.
10.7 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
¡ Security certificate of the Wi-Fi
communication module (to ensure
a secure data connection).
¡ The current software and hardware
version of your appliance.
¡ Status of any previous reset to
factory settings.
This initial registration prepares the
Home Connect functions for use and
is only required when you want to
use the Home Connect functions for
the first time.
Home Connect en
for six seconds
23