Bosch KGN56 Serie Manuel D'utilisation page 19

operation
7 Basic operation
operation
7.1 Switching on the appli-
ance
Electrically connect the appliance.
1.
→ Page 16
Note: If the appliance has been
previously switched off using the
control panel, press and hold
for three seconds.
a The appliance begins to cool.
a A warning signal sounds and the
temperature display flashes be-
cause the freezer compartment is
still too warm.
Switch off the warning tone using
2.
.
goes out as soon as the set
a
temperature has been reached.
Set the required temperature.
3.
→ Page 19
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
¡ The temperature in the appliance
varies due to the following condi-
tions:
– How often the appliance is
opened
– Load capacity
– Temperature of newly stored
food
– Ambient temperature
– Direct sunlight
7.3 Switching off the appli-
ance
Press and hold
▶
three seconds.
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
Press the required temperature.
▶
To reach the set temperature, slide
the temperature controller for the
storage container to a position that
is one third from the bottom.
→ Page 19
The recommended temperature in
the refrigerator compartment is
4 °C.
Setting the storage container
temperature
To reduce the temperature, slide
1.
the temperature controller in the
direction.
To increase the temperature, slide
2.
the temperature controller in the
direction.
→ Fig.
6
Setting the freezer compartment
temperature
Press the required temperature.
▶
The recommended temperature in
the freezer compartment is
−18 °C.
operation en
for
19