ADE WS 1502 Mode D'emploi page 53

Start-up
Outdoor sensor
1. Remove the battery compartment cover on the rear
2. Insert 2 batteries of type LR03 (AAA)/1.5 V as depicted
3. Slide the battery compartment cover back into place
Weather Station with Wireless Outdoor Sensor WS 1502/1503
FW Station.indb 53
‚ Proceed in the order specified below and first
insert the batteries into the outdoor sensor.
Only then can the weather station function
without flaws.
‚ Do not use rechargeable batteries, since their
voltage is too low (only 1.2 V instead of 1.5 V).
This affects, among other things, the precision
of the measurements.
‚ Where possible, use alkaline rather than zinc-
carbon batteries. Alkaline batteries last longer,
especially at low outdoor temperatures.
side of the outdoor sensor by pressing with a little force
on the imprinted arrow. Slide the battery compartment
cover in the direction of the arrow, away from the
outdoor sensor.
on the bottom of the battery compartment. Pay
attention to the correct polarity of the batteries (+/-).
on the outdoor sensor.
53
21.09.2015 09:45:59