Publicité
Les langues disponibles
Les langues disponibles
4
Preparation
4.1. Things to be done for energy saving
mehmet
Connecting the product to electric energy
A
saving systems is risky as it may cause
damage on the product.
For a freestanding appliance; 'this refrigerating
appliance is not intended to be used as a built-in
appliance.
Do not leave the doors of your refrigerator open for
a long time.
Do not put hot food or drinks in your refrigerator.
Do not overload the refrigerator, cooling capacity will
fall when the air circulation inside is hindered.
Since hot and humid air will not directly penetrate
into your product when the doors are not opened,
your product will optimize itself in conditions
sufficient to protect your food. Functions and
components such as compressor, fan, heater,
defrost, lighting, display and so on will operate
according to the needs to consume minimum
energy under these circumstances.
To be able store maximum food in the freezer
compartment of your refrigerator, the upper flap
and drawer must be removed and placed on top of
glass shelves. Power consumption stated for your
refrigerator has been determined after removing the
icebox, ice tray and flap and the middle drawer as
to allow maximum loading. Using the upper flap and
lower drawer while loading is highly recommended.
Depending on the features of your product, thawing
frozen food in fridge compartment will both provide
energy saving and preserve the food quality.
Airflow should not be blocked by placing foods in
front of the freezer compartment fan. Foods should
be loaded by leaving minimum 5 cm space in front
of the protective fan grid.
The temperature sensor in the freezer compartment
must not directly contact food packages. In case of
contact with the sensor, the power consumption of
the product may increase.
C
Inside of your product must be cleaned.
C
If two coolers are to be installed side
by side, there should be at least 4 cm
distance between them.
4.2. Initial use
Before starting to use your refrigerator, ensure that
all preparations are made in accordance with the
instructions in sections "Instructions for safety and
environment" and "Installation".
Run the product without putting any food for 6 hours
and do not open its door unless certainly required.
C
You will hear a noise when the compressor
starts up. The liquids and gases sealed
within the refrigeration system may also
give rise to noise, even if the compressor is
not running. This is normal.
C
It is normal that the front edges of
the refrigerator are hot. These areas
are designed to be warm to avoid
condensation.
10 /25EN
Refrigerator / User Manual
Publicité
