Publicité
Les langues disponibles
Les langues disponibles
Problem
Food does not
broil properly
Control signals after
entering cooking time
or delay start
Display flashes "bAd"
then "linE" with a
loud tone
Surface units do
not work
The words "CLOSE
DOOR" flashes or
scrolls in the display
Possible Causes
Improper rack position
being used.
Food being cooked in a hot pan.
Aluminum foil used on the
broiling pan and grid has
not been fitted properly
and slit as recommended.
In some areas the power
(voltage) may be low.
You forgot to enter a bake
temperature or cleaning time.
The installed connection
from the house to the unit
is miswired.
There has been a main power
supply surge and/or a power
interruption and surge
This is a normal condition.
The "CLOSE DOOR" is a reminder
message to keep the oven door
closed during broil mode
What To Do
• See the Broiling guide.
• Use the broiling pan and grid that came with your range.
Make sure it is cool.
• See the Using the oven section.
• Preheat the broil element for 10 minutes.
• Broil for the longest period of time recommended
in the Broiling guide.
• Press the BAKE pad and desired temperature or the CLEAN
pad and desired clean time.
• Contact installer or electrician to correct miswire.
• On the Control Panel, activate the Self Clean mode
(press the SELF CLEAN button)
• Wait for 30 seconds and then press the OFF button.
• The cooktop should now be ready to operate
• This is normal. Keep oven door closed during broil mode
GEAppliances.ca
29
Publicité
