Publicité
Les langues disponibles
Les langues disponibles
Before you call for service...
Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Problem
Radiant Cooktops
Surface units will not
maintain a rolling boil
or cooking is not
fast enough
Surface units do
not work properly
Scratches (may appear
as cracks) on cooktop
glass surface
Areas of discoloration
on the cooktop
Plastic melted to
the surface
Pitting (or indentation)
of the cooktop
Frequent cycling
off and on of
surface units
Surface indicator lights
turn on, but surface units been set.
do not work
Surface unit stops
glowing when turned
to a lower setting
Possible Causes
Improper cookware
being used.
A fuse in your home may be
blown or the circuit breaker
tripped.
Cooktop controls
improperly set.
Incorrect cleaning
methods being used.
Cookware with rough bottoms
being used or coarse particles
(salt or sand) were between
the cookware and the surface
of the cooktop.
Cookware has been slid
across the cooktop surface.
Food spillovers not cleaned
before next use.
Hot surface on a model
with a light-colored glass
cooktop.
Hot cooktop came into
contact with plastic placed
on the hot cooktop.
Hot sugar mixture spilled
on the cooktop.
Improper cookware
being used.
The self-clean cycle has
This is normal. The unit
is still on and hot.
What To Do
• Use pans which are flat and match the diameter
of the surface unit selected.
• Replace the fuse or reset the circuit breaker.
• Check to see the correct control is set for the surface
unit you are using.
• Scratches are not removable. Tiny scratches will become
less visible in time as a result of cleaning.
• To avoid scratches, use the recommended cleaning
procedures. Make sure bottoms of cookware are clean
before use, and use cookware with smooth bottoms.
• See the Cleaning the glass cooktop section.
• This is normal. The surface may appear discolored
when it is hot. This is temporary and will disappear
as the glass cools.
• See the Glass surface potential for permanent damage
section in the Cleaning the glass cooktop section.
• Call a qualified technician for replacement.
• Use only flat cookware to minimize cycling.
During a self-clean cycle, the surface units will not
work Press the OFF pad to stop the self-clean cycle
or wait until the self-clean cycle is finished to set
and use the surface units See the About the radiant
surface units section
GEAppliances.ca
27
Publicité
