Hoover HFB 6B2S3FX Manuel D'utilisation page 108

2. "SETTING" appears on the display.
3. Press the "PROGRAMME SELECTION"
button until "BUZZER" appears on the
display.
4. Then press either the button "HALF
LOAD" or "EXTRA DRY" to change
the value from Yes to No.
5. Switch off the dishwasher by pressing
the "ON/OFF" button to confirm the new
setting.
To turn the alarm on again, follow the same
procedure.
MEMO FUNCTION (Memorising
the last programme used)
1. Hold the "PROGRAMME SELECTION"
button down and, at the same time,
switch on the dishwasher using the
"ON/OFF" button.
2. "SETTING" appears on the display.
3. Press the "PROGRAMME SELECTION"
button until
appears on the display.
4. Then press either the "HALF LOAD" or
"EXTRADRY" button to change the
programme.
5. Switch off the dishwasher by pressing
the "ON/OFF" button to confirm the new
setting.
To change the stored programme, follow
the same procedure.
Enabling or disabling DEMO
MODE (be used exclusively in
stores)
Enabling
The dishwasher must ALWAYS be off
before you start this procedure.
1.Turn on the
ON/OFF button.
2.Press the "PROGRAMME SELECTION"
and "DELAY START" buttons together
for 5 seconds.
"MEMO FUNCTION"
appliance using
3. "DEMO
appear on the display.
4.If no button is pressed for 30 seconds,
the programme will start, simulating the
start of a wash programme.
The PROGRAMME SELECTION/ OPTIONS/
DELAY START options are enabled, and
by pressing these buttons you can simulate
the product's functioning without starting
a wash.
Disabling "Demo mode"
WARNING
Once installed, if the appliance works
correctly but the wash cycle does not
start upon pressing the Start button,
"Demo mode" may not have been disabled.
The dishwasher must ALWAYS be off
before you start this procedure.
1. Turn on the appliance using the On/Off
button.
2. Press the "PROGRAMME SELECTION"
and "DELAY START" buttons together
for 5 seconds.
3. "DEMO MODE DISABLED" will appear
on the display.
4. Switch off the appliance.
CHILD LOCK
⚫
Pressing the EXTRA DRY and DELAY
START buttons at the same time for
about 3 seconds allows you to lock all
keys. In this way, you can prevent any
unwanted or accidental changes.
⚫
The key lock can be cancelled by simply
pressing the EXTRA DRY and DELAY
START buttons again or by switching off
the appliance.
the
Should power go out when the dishwasher
is running, a special memory feature
saves the settings and, when power
returns, the appliance resumes the cycle
from where it left off.
108
MODE ACTIVATED" will