Hoover HFB 6B2S3FX Manuel D'utilisation page 107

This option is automatically enabled in the
"ECO" programme. In any case, it is
possible to disable it. The "OPEN DOOR"
feature is not available in the "RAPID 39'",
"RAPID 29'" and "PREWASH" programmes.
WARNING
With this option selected, you must not in
any way prevent the door from opening or
force it shut, as this would damage the
mechanism. Ensure that there is free space
in front of the door and, before closing, wait
for the opening device to complete its activity.
"HALF LOAD" button
(only on some models)
If you need to wash just a few dishes (e.g.
glasses, cups, plates), you can enabled the
"HALF LOAD" option. In this way, you can
save water, energy and time. With the "Half Load"
option, use less detergent than for a full load.
"EXTRA DRY" button
(only on some models)
This option allows you to achieve the
highest efficiency in drying, increasing the
wash water temperature during the last
phase of the wash cycle.
"SALT EMPTY" indicator light
When the indicator light comes on, fill the
salt container.
"RINSE AND EMPTY" indicator
light
When the indicator light comes on, the rinse
aid is running out and needs to be topped
up.
"DELAY START" button
Dishwasher start time can be set with this
button, delaying start from 1 to 23 hours.
Proceed as follows to set a delayed start:
⚫
Press the DELAY START button ("0:00"
will appear on the display).
⚫
Press the button again to increase the
delay in hours (each time the button is
pressed, the delay is increased by 1 hour
to a maximum of 23).
If you do not want a delayed start, press
the DELAY START button repeatedly
until 0:00 appears on the display (the
appliance will start immediately).
⚫
To start the countdown, press the
"START/RESET" button. The display will
show the time remaining to the end of the
programme. At the end of the countdown,
the programme will start automatically.
(Only for free-standing models)
The length of the selected cycle will
be shown on the display. At the end of
the countdown, the programme will
automatically start and the length of
the selected cycle will be shown on
the display.
Proceed as follows to cancel a delayed start:
⚫
Hold the "START/RESET" button down
for at least 3 seconds. "00" will appear on
the display "RESET" and audible signals
will sound.
⚫
The delayed start and the selected
programme will
dashes will appear on the display.
⚫
At this point, to set off the dishwasher, a
new programme and any option buttons
must be selected, as indicated in the
"PROGRAMME SETTINGS" paragraph.
Muted END-OF-PROGRAMME signal
The product is set in the factory with the
audio signal enabled.
The audio signal may be muted as follows:
The dishwasher must ALWAYS be off
before you start this procedure.
1. Hold the "PROGRAMME SELECTION"
button down and, at the same time,
switch on the dishwasher using the
"ON/OFF" button.
107
be cancelled. Two