Hoover HFB 6B2S3FX Manuel D'utilisation page 105

When the door is shut, after an audible signal
has sounded, the programme will start
automatically. The display will show the time
remaining to the end of the wash cycle.
After switching on the dishwasher,
wait a few seconds for the programme
to start running.
"AUTOMATIC" programmes
(only on some models)
Models with Smart Loading Sensor
(Only on some models).
The "AUTO CARE" programme, thanks to
an algorithm that analyses the degree of
dirtiness of the dishes in real time,
automatically sets the ideal temperature
and washing time , optimising water and
electricity consumption
Models with dirt sensor
(Only on some models).
The dishwasher is equipped with a dirt sensor,
capable of analysing water murkiness during all
"AUTOMATIC" programme phases (see
programme legend). Thanks to this device,
the wash cycle parameters are automatically
adapted to the real quantity of dirt on dishes.
This is because water murkiness is linked to the
quantity of dirt on dishes. Thus, excellent
washing results are guaranteed while
optimising water and energy consumption.
"IMPULSE" programmes
The "IMPULSE"
impulse washing technology, which reduces
consumption and noise, and improves
performance.
The "intermittent" working of the
washing pump
considered a malfunction; it is a
characteristic of impulse washing,
and therefore should be considered a
normal feature of the programme.
programmes use
is NOT to
ADDISH
dishes after the programme has
started)
When the programme starts, you should
only open the door and add more dishes
when the ADDISH indicator light is switched
on. The appliance will stop automatically and
the time remaining to the end of the cycle will
flash on the display. Close the door, without
pressing any buttons.
The cycle will start from where it left off. When
the relating indicator light switches off, it is no
longer advisable to add further dishes.
Open the door slowly and carefully, to
avoid getting wet with splashes of
washing water.
Adding dishes
indicator light has switched off is
strongly discouraged as this could
affect the wash performance.
(Only for free-standing models)
The ADDISH feature can be used, even
without opening the door, by pressing
the Start/Reset button. In this case,
simply press the Start/Reset button again
to restart the cycle from where it left off.
WARNING
If you open the door during the drying
cycle, an intermittent audio signal
advises you that the drying cycle has
an
not yet finished.
Changing a running programme
Proceed as follows to change or cancel a
be
running programme:
⚫
Hold the "RESET" button down for at least
3 seconds. "START/RESET" will appear
on the display and audible signals will
sound.
105
(possibility of adding
after the ADDISH