Publicité
Les langues disponibles
Les langues disponibles
3. Select the right hooks for installation, there are two hooks on
the R and P bracket, depends on the cabinet depth, select
the right hook before installation.
A
A. P Hook
B. R Hook
C. P and R Bracket
Cabinet Depth
15" < Deeper ≤ 15
P
(38.1 cm < Deeper ≤ 39.4 cm)
15
/
" < Deeper ≤ 16"
1
2
R
(39.4 cm < Deeper ≤ 40.6 cm)
4. For example, the cabinet depth is 15
and put the P hooks facing out.
5. Fasten P and R bracket with the screws which uninstalled in
step 2.
Attach Bump Out Mounting Plate to Wall
NOTE: Secure the mounting plate to the wall at both end holes
drilled into the wall studs and/or drywall using either
3/16-24 x 3" round-head bolts and toggle nuts and 1/4 x 2" lag
screws. Refer to illustrations in "Possible Wall Stud
Configurations" in the "Locate Wall Stud(s)" section.
10
C
B
/
"
1
2
/
", choose the P hook,
1
4
A
A. P Hook
A
A. Screws
No Wall Studs at End Holes (Figure 1)
NOTE: The mounting plate must be secured to the wall on at
least 1 wall stud as well as at both ends.
1. With the support hooks of the mounting plate facing forward,
insert 3/16-24 x 3" round-head bolts through both end holes
(A and B), insert 1/4 x 2" lag screws (D, E, H, and J).
C
A
H
A and B. Two End Holes
C. Wall Studs
D, E, H, and J. Four Lag Screw Holes
NOTE: Start toggle nuts on bolts from the back of the mounting
plate. Leave enough space for the toggle nuts to go through the
wall and to open.
A
A. 3/16-24 x 3" round-head bolt
B. Mounting plate
C. Spring toggle nut
2. Position mounting plate on the wall.
3. Push the 2 bolts with toggle nuts through the drywall, and
finger tighten the bolts to make sure toggle nuts have opened
against drywall.
A
B
A. 3/16-24 x 3" round-head bolt
B. Mounting plate
C. Spring toggle nut
D. Drywall
.
D
E
B
C
C
D
C
J
B
Publicité
