Publicité
Les langues disponibles
Les langues disponibles
6. Place and tape the upper cabinet template against the
bottom of the upper cabinet.
NOTES:
Make sure the L line on the upper cabinet template align
■
with the back edge of upper cabinet.
Make sure the center marks on the upper cabinet
■
template align with the upper cabinet centerline which
draw in step 1.
D
13"< L ≤14"
B
C
A. Upper Cabinet Centerline and Upper
Cabinet Template Centerline
B. Back edge of the Upper Cabinet
C. L Line on Upper Cabinet Template
D. Center Marks on Upper Cabinet Template
Mark Rear Wall
The microwave oven must be installed on a minimum of 1 wall
stud, preferably 2, using a minimum of 1 lag screw, preferably 2.
See "Find the Wall Stud(s)" section for find the wall studs.
1. Using measuring tape, find and clearly mark the vertical
centerline of the opening.
A
A. Centerline
2. Tape the Wall template in place. Align the center mark on the
wall template over the vertical centerline draw in step 1. Make
sure the wall template is level, and that the top of the wall
template is butted up against the bottom edge of the upper
cabinet.
C
A. Bottom Edge of Upper Cabinet and Top of
the Wall Template
B. Center Marks on Wall Template
C. Centerline
A
13"< L ≤14"
A
B
NOTE: If the front edge of the upper cabinet is lower than the
back edge, lower the wall template so that its top is level with the
front edge of the cabinet.
A
C
B
A. Rear wall
B. Back edge of the Upper Cabinet
C. Top of wall template must align
with front edge of cabinet
D. Front edge of upper cabinet
Drill Holes in Upper Cabinet
1. Using a 3/4" (1.9 cm) hole saw, cut out the power cord hole
(A), which is "G" on the upper cabinet template.
2. Drill two mounting nut holes (B), which are 3/8" (10 mm) holes
at points "D" and "E" on the upper cabinet template. These
are for two 1/4-20 x 3" bolts and washers used to secure the
microwave oven to the upper cabinet.
A. Power Cord Hole
B. Mounting Nut Holes
NOTE: If upper cabinet is metal, the supply cord bushing
needs to be installed around the supply cord hole as shown.
A
A. Metal cabinet
B. Power supply cord bushing
D
B
A
B
7
Publicité
