Publicité
Les langues disponibles
Les langues disponibles
Installation for Wall Studs at Both End Holes (See figure 4 in
the "Locate Wall Studs" section)
1. Drill four 3/16" (5 mm) lag screw hole(s) into the wall studs
and wall at the hole (A, B, H, and J).
2. Drill 5/8" (1.6 cm) holes through the wall at the hole (D and E).
C
F
A
H
D
A and B. Two End Holes
C. Wall Stud
D, E, H, and J. Four Lag Screw Holes
F. Wall Template
Prepare the Bump Out Mounting Plate
The default bump out mounting plate with L bracket is used for
the upper cabinet larger than 13" and up to 14" depth. If your
cabinet is 14" to 15", uninstall the L bracket, replace it with the M
and N bracket. If your cabinet is 15" to 16", replace it with the
P and R bracket. Use the right bracket before attach the bump
out mounting plate onto the wall.
If your upper cabinet is larger than 13" and up to 14" depth.
1. Take out the bump out mounting plate, which is folded, open
it to 180 degree at plate.
2. Attach the bump out mounting plate to wall, follow the steps
in "Attach Bumpt Out Mounting Plate to Wall" section.
If your upper cabinet is larger than 14" and up to 15" depth.
1. Take out the bump out mounting plate, which is folded, open
it to 180 degree at plate.
2. Uninstall the L bracket from the plate. Keep the L bracket for
future use.
B
C
A. L Brackets
B. Plate
C. Screws
3. Select the right hooks for installation, there are two hooks on
F
B
J
E
4. For example, the cabinet depth is 14
5. Fasten M and N bracket with the screws which uninstalled in
If your upper cabinet is larger than 14" and up to 15" depth.
1. Take out the bump out mounting plate, which is folded, open
2. Uninstall the L bracket from the plate. Keep the L bracket for
A
the M and N bracket, depends on the cabinet depth, select
the right hook before installation.
A
A. M Hook
B. N Hook
C. M and N Bracket
Cabinet Depth
14" < Deeper ≤ 14
M
(35.6 cm < Deeper ≤ 36.8 cm)
14
/
" < Deeper ≤ 15"
1
2
N
(36.8 cm < Deeper ≤ 38.1 cm)
and put the N hooks facing out.
A. N Hook
step 2.
A. Screws
it to 180 degree at plate.
future use.
B
C
A. L Brackets
B. Plate
C. Screws
B
C
/
"
1
2
/
", choose the N hook,
3
4
A
A
A
9
Publicité
