Publicité
Les langues disponibles
Les langues disponibles
7
Getting started/setup
DR 315 C is a sophisticated multi-source media player. To simplify the set up process as
much as possible, when DR 315 C is first started a setup wizard helps take you through
the basic steps to enable connections with the different audio sources.
The various listening modes have different requirements:
• Internet Radio requires a suitable internet broadband connection (usually wireless network).
• Music Player requires connection to wireless network connected device.
• DAB/FM requires a DAB/FM broadcast signal via the built in antenna.
• Aux-In requires connection via the Aux-In socket.
To start DR 315 C, connect the unit to a suitable power source using the power supply
provided. The unit starts up. (there may be a few seconds delay before the display is
initialised)
After showing a Starting screen DR 315 C will normally enter the last used listening mode.
The first time DR 315 C is started (or after being reset to factory settings) the setup wizard
is launched automatically.
7.1
Setup wizard
When DR 315 C is started for the first time, it runs through a setup wizard to configure settings
for date/time and network. Once this has finished, the system is ready to use in most modes.
* Note: To change these settings later, select Menu > System settings > and select the
required settings option.
To run the setup wizard again, select Menu > System
settings > Setup wizard.
Select Yes to start the setup wizard.
If you choose No, the next screen asks if you would like
to run the wizard next time DR 315 C is started. The
system then starts without configuring time/date and
network settings and enters the Main Menu.
The Setup wizard guides you through the basic setup parameters for Time/Date and Network
connection. For details see the relevant settings in section 8 Settings. To change any settings
later all setting functions are accessible from the Settings Menu.
English
49
Publicité
