Using Your Rotisserie Burner - Jenn-Air 720-0727 Instructions D'installation Et Guide D'utilisation Et D'entretien

6. Push in and turn the burner knob to IGNITE/HI for the burner
closest to the lit match. The burner will light immediately.
When burner is lit, turn knob to desired setting.
7. Repeat steps 3 through 6 for each burner.
8. Remove match and replace manual lighting extension on the
right side panel.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to light them manually,
contact the Customer Service Center. See the "Assistance"
section.

Using Your Rotisserie Burner

A Rotisserie kit can be purchased as an accessory for the grill.
See "Accessories" in the "Assistance" section.
To avoid damage to the warming rack, remove from grill when
using the rotisserie burner.
IMPORTANT: Do not use the main burners when the rotisserie
burner is in use.
Lighting the Rotisserie Burner
1. Open the hood completely. Do not light burners with the hood
closed.
2. Do not lean over the grill.
3. Push in and turn the control knob to IGNITE/ON. You will hear
the "snapping" sound of the spark.
4. When the rotisserie burner lights, continue to hold the knob in
for another 10 seconds, then release the knob and burner will
stay lit. You will hear the "snapping" sound of the spark until
the knob is released.
IMPORTANT: If the rotisserie burner does not light immediately,
turn the burner knob to OFF and wait 5 minutes before relighting.
Manually Lighting the Rotisserie Burner
1. Open the hood completely. Do not light burners with the hood
closed.
2. Do not lean over the grill.
3. Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
4. Strike the match to light it.
5. Gently hold the lit match close to the rotisserie burner.
A
A. Lighting extension
B. Rotisserie burner
6. Push in and turn the control knob to IGNITE/ON. Hold this
knob in for 10 seconds after the burner is lit. You will hear the
"snapping" sound of the spark until after the knob is released.
IMPORTANT: If the rotisserie burner does not light
immediately, turn the rotisserie burner control knob to OFF
and wait 5 minutes before relighting.
7. Remove the match and replace the manual lighting extension
inside the cabinet door.
B
23