Jenn-Air 720-0727 Instructions D'installation Et Guide D'utilisation Et D'entretien page 13

3. Connect the quick connector on the other end of the
10 ft (3.0 m) PVC flexible gas supply hose to the rigid Natural
gas supply pipe.
A
B
A. Manifold
B. Left side panel
C. Natural gas pressure regulator/hose assembly
D. 10 ft. (3.0 m) PVC gas hose
Change Grill Burner Valve Orifices
1. Remove the grates and flame tamers.
2. Remove the 2 screws that hold the burner in place. Set the
screws aside. Remove the burner from the grill by lifting the
burner out.
D
C
A
A. 2 screws
3. Use a 6 mm socket and wrench or 6 mm nut driver to remove
the brass orifice from the end of gas valve. The main burner
orifice is located behind the LP orifice, so no additional orifice
needs to be installed.
A. Main burner orifice
IMPORTANT: Check that the orifice is properly installed
inside of the burner opening.
4. Reinsert the burner and reattach using the 2 screws
previously removed. Repeat the procedure for each main
burner.
5. Position the igniters so they are ¼" (6.0 mm) away from each
burner.
Change the Rotisserie/Infrared Burner Orifice
1. Using a Phillips screwdriver, unscrew the 2 screws and
remove the rotisserie/infrared burner wind baffle.
A. Wind baffle
A
A
13