Tectro TS 133 Manuel D'installation page 56

1. Fit the Installation Plate
1. Fit the installation plate
tion plate.
2. If the wall is made of brick, concrete or the like, drill eight (8) 5mm diameter holes in the wall. Insert
Clip anchor
3. Fit the installation plate
NOTE
Fit the Installation Plate and drill holes in the wall according to the wall structure and
corresponding mounting points on the installation plate. (Dimensions are in "mm" unless
otherwise stated)
90
Over 12 cm from the wall
40
Over 12 cm from the wall
133
Left rear side refrigerant
4
56
horizontally on structural parts of the wall with spaces around the installa-
for appropriate mounting screws
on the wall with eight (8) type "A" screws
Indoor unit outline
Installation plate
70 70
Left rear side refrigerant
750
pipe hole Ø65
A:780 (< 4.6 kW model)
Indoor unit outline
920
pipe hole Ø65
Wall
Indoor
Fig. 6
.
150 mm or more to ceiling
920 (4.6 kW ≤ model < 6.1 kW)
150 mm or more to ceiling
50
1036 ≥ 6.1 kW model
Fig. 5
Outdoor
≥5°
.
Installation plate
Over 12 cm
from the wall
Right rear side
refrigerant pipe
hole Ø65
Installation plate
Over 12 cm from the wall
Right rear side
refrigerant pipe
hole Ø65