Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
Please always wait 3 minutes when turning unit off and then on again, and when changing from cool to fan
and back to cool. This prevents the compressor from overheating and possible circuit breaker tripping.
AUGER WHEEL
Thermostat
The thermostat is used to set the desired room temperature when the unit is being operated
in the "COOL MODE" .
To change the room temperature, rotate the thermostat switch to the desired setting. After
the set temperature is achieved the thermostat will automatically start and stop the compressor
in order to maintain the desired set temperature.
Rotate the thermostat selector clockwise for higher cool settings. Higher cool settings will
provide lower room temperature.
Rotate the thermostat selector counter clockwise for lower cool settings. Lower cool settings
will provide higher room temperature.
Cool Mode
The desired cool setting is selected by rotating the knob to the right to the appropriate location.
"hi cool " has maximum cooling effect and airflow.
"lo cool " has minimum cooling effect and airflow.
Note: If your unit is equipped with a vent handle, keep it closed for maximum efficiency.
Fan Mode
Rotate the knob to the left to select your choice of fan speeds for air circulation.
Note: When selecting a fan speed, the compressor will not run.
WARNING
Air Directional Louvers
Air directional louvers control air flow direction. Your air conditioner has
the louver type described below.
Auger T ype
Rotate the Auger Wheels until the desired Left/Right direction is obtained.
9
Publicité
