Publicité
Les langues disponibles
Les langues disponibles
before using your Kenwood
appliance
Read these instructions carefully and
G
retain for future reference.
Remove all packaging and any
G
labels.
safety
Do not use the juicer if the filter is
G
damaged.
Do not operate the juicer without
G
the pulp collector fitted.
The cutting blades on the base of
G
the filter are very sharp, take care
when handling and cleaning the filter.
Never put the motor unit, cord or
G
plug in water – you could get an
electric shock.
Switch off and unplug:
G
before fitting or removing parts
G G
before cleaning
G G
after use.
G G
Never use a damaged juicer. Get it
G
checked or repaired: see 'Service
and customer care'.
Only use the pusher supplied. Never
G
put your fingers in the feed tube.
Unplug and take the juicer apart
before unblocking the feed tube.
Before removing the lid, switch off
G
and wait for the filter to stop.
Never let the cord touch hot
G
surfaces or hang down where a child
could grab it.
Don't touch moving parts.
G
Never leave the juicer on
G
unattended.
This appliance is not intended for
G
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
Children should be supervised to
G
ensure that they do not play with the
appliance.
English
Only use the appliance for its
G
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is
G
the same as the one shown on the
underside of your juicer.
This appliance conforms to EC
G
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using for the first time
Wash the parts: see 'care and
G
cleaning'.
key
pusher
extra large feed tube
lid
lid tab
filter
filter holder
filter holder interlock
anti-drip spout
interlock latches
power unit
lid with foam separator
juice jug
on/off speed control
pulp collector
cord storage
using your juicer
assembly and use
1 Fit the filter holder
2 Fit the filter
3 Fit the lid
the lid
filter holder
4 Lock the lid by clipping the top of
the latches
the bottom of the latches
place.
Your juicer will not operate if
G
the lid is not fitted correctly.
2
.
inside the filter holder.
by aligning the tab on
with the interlock on the
.
to the lid. Then snap
into
Publicité
