32 | English
Problem
Possible Cause
Mower standing on
Operational problems
lawn with the display
switched off
Mower does not
Battery too hot/cold
charge
Docking station not switched on
Charging pins corroded
Battery not fitted, incorrectly fitted or in-
correct battery for mower
Mower out of peri-
Perimeter wire on a slope
meter wire
Obstacle near perimeter wire
Parts of the lawn area
Mower requires more cuts to finish garden Allow mower to run for 3 full cuts to cover whole lawn
left uncut
Time slot not long enough for garden size
Distance between perimeter wires too
small
Rough mowing conditions
Grass too long
Slopes in garden too steep
Mower gets stuck in
Objects/obstacles not marked out
garden
Newly laid turf
Mower unintentionally
Objects/obstacles below 5 cm not marked
cuts flowers, etc. or
out
runs over certain
obstacles
Mower does not ap-
LogiCut system depends on the garden
pear to cut logically
conditions. Mower does not necessarily
have to continue in the next uncut area.
F 016 L94 038 | (11.11.2020)
Corrective Measure
Press confirm button for screen to light up, or place
mower in docking station.
The mower operates when the battery internal temperat-
ure is between 5 °C – 45 °C. Allow mower to cool down/
warm up. If the error occurs frequently, the docking sta-
tion should be positioned in the shade.
Switch on power supply to docking station. If docking
station does not start, contact your Bosch Service
Centre.
Clean the charging pins.
Insert battery correctly (see figure L). Use the appropri-
ate Bosch battery.
Leave 30 cm between the perimeter wire and the slope.
Remove obstacle.
area. Alternatively use the "Intensive mode" under "Mow-
ing mode".
Increase mowing time slot or:
– use "Bosch AUTO" calendar function (with Indego
S 500 and M 700)
– use Bosch "SmartMowing" functionality (with In-
dego S+ 500 and M+ 700)
Increase distance between the perimeter wires to a min-
imum of 75 cm.
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Flatten garden/remove/bumps/mark out unsuitable
areas with the perimeter wire – Please follow the instruc-
tions in the Installation Guide.
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Ensure mower only operates on slopes of 15 degrees or
less and full garden is not on a slope.
Use the perimeter wire to mark off obstacles where the
mower often gets stuck.
Allow a few weeks for the soil to settle before using the
mower.
Change setting in menu item "lawn condition / bump
sensor" to low sensitivity / uneven.
After watering, wait as long as possible until you start the
mower.
Mark obstacle using perimeter wire leaving 30 cm from
object or remove objects/obstacles.
Further information can be found on the Installation
Guide.
If behaviour re-occurs often, remap garden.
Bosch Power Tools