Wamsler F-BOX 113 10 Mode D'emploi page 28

1.3 Putting out of operation
• Let the glowing ember burn to ashes and the fire-place get cold.
• Empty the furnace chamber and the ash bin.
•
Close the doors, and shut off the primary air regulator and the fuel switch
1.4 Heating instructions
The fireplace should be operated only with closed furnace chamber door. Fireplaces
belonging to type 1 have self-locking furnace chamber doors. These doors may be
opened only for kindling, loading or when cleaning the furnace chamber (otherwise
draught problems may occur with other equipment connected to the same chimney).
When opening the furnace chamber door, any incorrect handling or insufficient
draught may induce smoke. Always ensure that the furnace chamber door may be
opened only slowly, first just to a small extent, and then fully after a few seconds.
In addition, if you intend to put additional fuel into the fire, before the opening of
the door only there may be only ember bed in the burning space, i.e. no flames
may be visible.
Led into the burning space in correspondence with the existing conditions, the
secondary air provides for the follow-up burning of the combustible components of in the
burning space. This in fact means smoke and soot-poor burning, which contributes to
the protection of the environment. If you wish to commission the fireplace in a
transitional period, please, please first examine the chimney draught, as it can be
especially weak at high external temperatures. Towards this end, hold a burning match
in the slightly opened feeding door. If the flame is not drawn significantly by the draught,
then a so-called starting fire is to be set first. Towards this end, burn wood chips/wool in
the fireplace or the cleaning hole of the chimney. The fire grate is to be cleaned before
every kindling to ensure the proper inflow of air for burning. The ashtray is to be emptied
regularly (Figure 3). Should the equipment be extremely hot, use the gloves provided.
Please, be careful not to dispose glowing materials into the waste bin.
Ensure that the ashtray should be fully pushed into the equipment.
Warning!
In order to keep the air clean and safeguard the fireplace, do not exceed the
specified maximum fuel quantity; otherwise overheating may occur, which
potentially damage the equipment. Such damage is not covered with any
guarantee. Only a single layer of fuel is allowable to be prepared in the fireplace.
Try to reach lower heating performance only by decreasing the quantity of fuel,
and not by cutting the primary air supply.
Warning!
28
.