Publicité
Les langues disponibles
Les langues disponibles
Adjustment:
Fuel
Warning up,
kindling
Wood
Brown-coal
Putting out of working
order
IT IS NOT ALLOWED to burn waste, fine chipping, bark, wood handled with preventive
chemicals, furthermore paper and cardboard. For kindling please use wood scrapings or
grill starter but never use liquid auxiliaries!
The first kindling
•
At the first fire set-up could be a little smoke, but is not dangerous, normal!
In this time, please ventilate the room carefully!
Warning! Upon the first kindling, smoke and unpleasant smell may be generated.
Always ensure the proper ventilation of the room (by opening windows and
doors), and heat the fireplace at maximum rated heating performance. If with the
first heating the maximum temperature is not reached, the above-mentioned
effects may as well arise later on.
•
Before installation pull out the delivery securer off the refractory brick through the
furnace chamber (picture no. 5).
Open the door by raising the handle (Picture 1). If the equipment is hot, you can use
insulated gloves. Adjust the primary air regulator and the fuel switch (Picture 2)
according to the Table 2. Put coal lighter or wood wool onto the fire grate, followed by
wood chips. First insert small pieces of wood, and then larger ones, light them and close
the door again. When the wood burns quickly, and leaves sufficient glowing embers, put
additional fuel on the fire. Thereafter, adjust the primary air regulator and the fuel switch
according to the Table 2 („Adjustment"). The first kindling should be performed "finely"
with little fuel only, so that the parts of the fireplace are adapted to heat. During the first
kindling, the generation of smell is normal and absolutely undangerous
Nominal heating
performance
Nominal heating
performance
Setting of the
fuel selector "B"
OPEN
OPEN
CLOSED
CLOSED
Table 2
27
Setting of the primary
air regulator "A"
K
h
k
0
.
Publicité
