Publicité
STEP 3
Face frame only: Attach the rear
BLUM brackets to the back of the
cabinet using (2) #8 x 5/8" wood
screws for each bracket.
Note: Place (1) screw in one of
the top row corners and (1) screw
in the bottom row corners on the
opposite side (See Figure 3).
STEP 4
Face frame: Make sure both slides
are set back 1/8" from the edge of
the face frame while being supported
by their rear brackets. Attach both
slides to the face frame by using (2)
#8 x 5/8" pan head screws for each
side (See Figure 4A).
Frameless: Attach both the left and
right BLUM slides to the frameless
cabinet using (3) #8 X 5/8" wood
screws for each side. Make sure the
front of the slide is set back 1/8" from
the front edge of the cabinet (See
Figure 4B).
FIG. 3
FIG. 4
1/8"
FIG. 4B
1/8"
INSTALLATION INSTRUCTIONS: DRYING RACK DRAWER
3
Publicité
