Publicité
STEP 1
Install the right and left BLUM
release triggers on the bottom of
the drawer using (4) #6 x 1/2" pan
head screws (See Figure 1).
STEP 2
Install the figure 8 brackets onto
the front of the drying rack drawer
using the (2) #8 x 5/8" screws that
come inside the same bag with the
figure 8 brackets (See Figure 2A).
Line up the drying rack drawer
with the drawer front and transfer
the figure 8 mounting bracket
holes onto the drawer front. Then
pre-drill the marked locations
using a 7/64" drill bit, drilling only
3/8" deep to ensure you don't drill
through the front of the door.
Note: Be careful to not drill
through the drawer front.
Secure the drying rack drawer to
the drawer front using the figure
8 brackets and (2) #8 x 5/8" wood
screws provided in the pack (See
Figure 2B).
2
FIG. 1
FIG. 2A
FIG. 2B
Customer Service: 800-626-1126 | rev-a-shelf.com
Figure 8 Brackets
Publicité
