Kenmore POP-N-GO 125.81615910 Manuel D'entretien Et D'utilisation page 20

Always follow all safety precautions when performing maintenance to the PowerMate
WARNING
Electrical Shock Or Personal Injury Hazard
Always turn off and unplug vacuum
cleaner before performing maintenance
to the vacuum cleaner. Failure to do so
could result in electrical shock or personal
injury from vacuum cleaner suddenly
starting.
BELT CHANGING AND AGITATOR CLEANING
TO REMOVE BELT
1. Turn PowerMate
®
upside down and
remove four (4)
screws.
2. Turn PowerMate
®
handle release pedal and lower the swivel.
Loosen the rear and side latches. (A flat-
head screwdriver may be required.)
POWERMATE
right side up. Press
CARE
®
3. To remove cover, grasp the rear and pull
up.
4. Lift agitator assembly out and remove
worn belt.
5. Check and clean end cap areas. See
AGITATOR ASSEMBLY (page 21) for picture
of complete agitator assembly.
- 20 -
.
®