Kenmore POP-N-GO 125.81615910 Manuel D'entretien Et D'utilisation page 10

3. Lower wand from upright position by
pressing on the HANDLE RELEASE pedal.
4. Select a pile height setting by pressing
the height adjust pedal on the rear of the
PowerMate . The pile height setting shows on
®
the indicator.
5. Select a position on
the handle three-way
On/Off switch.
Turn vacuum cleaner
off.
Turn on the canister
motor only.
Turn on both the
canister and the
PowerMate motors.
®
Agitator will come on.
SUGGESTED PILE HEIGHT
SETTINGS
Attention: Refer to your carpet
manufacturers cleaning recommendations.
Some more delicate carpets may require
that they be vacuumed with the PowerMate
agitator turned off to prevent carpet
damage.
For best deep down cleaning, use the XLO
setting. However, you may need to raise the
height to make some jobs easier, such as
scatter rugs and some deep pile carpets,
and to prevent the vacuum cleaner from
shutting off. Suggested settings are:
HI – Shag, deep pile, super-soft, or
ultraplush carpets, and scatter rugs.
MED – Medium to deep pile.
LO – Low to medium pile.
XLO – The preferred setting for many
carpets and also for bare floors.
NOTE: To protect bare floors, place the 3-
way On/Off switch in the HARDFLOOR
position to turn off agitator rotation.
CAUTION
DO NOT leave the PowerMate
one spot for any length of time. Damage
to carpet may occur.
CAUTION
Product Damage Hazard
Use care if the PowerMate
left in the upright position as it may tip
over easily. Property damage can occur if
tipped.
- 10 -
®
running in
®
and wand is
®