Publicité
Les langues disponibles
Les langues disponibles
WARNING
Personal Injury Hazard
To avoid accidental agitator starting,
always turn off and unplug the vacuum
cleaner before cleaning the agitator area.
Failure to do so can result in personal
injury.
OVERLOAD PROTECTOR
The PowerMate
has built-in protection
®
against motor and belt damage should the
agitator jam. If the agitator slows down or
stops, the overload protector shuts off the
PowerMate
and the agitator status indicator
®
emits red light. The canister motor will
continue to run.
Agitator Status
Indicator
To correct problem:
vacuum cleaner, remove obstruction, then
turn on the vacuum cleaner again. The
agitator status indicator will be off.
If the problem persists, have the vacuum
cleaner serviced by a Sears or other
qualified service agent.
ELECTRONIC SUCTION CONTROL
The electronic suction control allows you to
change the power of the vacuum cleaner
suction motor. When increasing the suction
to the highest power, you will hear a click
and the suction control can be locked into
this position.
SUCTION
CONTROL
Increase
Suction
Decrease
Suction
PERFORMANCE/SAFETY FEATURES
Turn off and unplug
Increase suction
for upholsteries,
carpets, and bare
floors.
Decrease suction
for draperies and
lightweight rugs.
CHECK BAG INDICATOR
When the vacuum cleaner is running with
normal airflow, the light on the CHECK
BAG indicator is off. The light comes on
whenever the airflow becomes blocked.
If that occurs, check the disposable dust
bag, motor safety filter and other
possible clog locations shown in
REMOVING CLOGS (page 16).
To correct problem: See "Check Bag
Indicator activates" in
TROUBLESHOOTING (page 24).
NOTE: The light may come on when using
certain attachments due to reduced airflow
through attachment.
THERMAL PROTECTOR
This vacuum cleaner has a thermal
protector which automatically trips to
protect the vacuum cleaner from
overheating. If a clog prevents the normal
flow of air to the motor, the thermal
protector turns the motor off
automatically. This allows the motor to
cool in order to prevent possible damage
to the vacuum cleaner.
To correct problem: Turn off and unplug
vacuum cleaner to allow the vacuum
cleaner to cool and the thermal protector
to reset. Check for and remove clogs, if
necessary. Also check and clean or
replace any clogged filters. Wait
approximately fifty (50) minutes and plug
the vacuum cleaner in and turn back on
to see if the motor protector has reset.
If the problem persists, have the vacuum
cleaner serviced by a Sears or other
qualified service agent.
- 15 -
Publicité
