GB
SAFETY INSTRUCTIONS
Readthissafetyinstructionsthoroughly,beforeinstallingandstartingupthedeviceandstoreitin a safe
place.
If the device is handed over to another person, this manual is to be handed over along with it.
INSTALLATION
Theelectronicdevicemayonlybeinstalledbyqualifiedpersonnelfromaspecialistcompany(in Germany
inaccordancewithVDE0100,Part721).
Thefollowinginformationisintendedforspecialistswhoarefamiliarwiththeguidelinesandsafety
precautions to be applied.
SAFETY INSTRUCTIONS
Caution!
Safetyinstruction:failuretoobservethisinstructioncancausematerialdamageorpersonalinjury and
impair the proper functioning of the device.
Protect all drilled holes with anti-corrosive paint
Check again and fasten all screws.
Caution!
Safetyinstructionrelatingtodangeremanatingfromelectricalcurrentsorvoltage:failuretoobserve this
instruction can cause material damage or personal injury and impair the proper functioning of the device.
Themanufacturerwillnotbeheldliableforclaimsfordamageresultingfromthefollowing:
• Faultyassemblyorconnection
• Damagetotheapplianceresultingfrommechanicalinfluencesandexcessvoltage
• Alterationstothedevicewithoutexpresspermissionfromthemanufacturer
• Useforpurposesotherthanthosedescribedintheoperatingmanual
Warning!
Topreventshortcircuits,alwaysdisconnectthenegativeterminaloftheelectricalsystembefore-working
on the vehicle. If the vehicle has an additional battery, its negative terminal should also be disconnected.
Warning!
Inadequatesupplycableconnectionscouldresultinshortcircuitswiththeconsequencethat:
• cablefiresoccur
• theairbagistriggered
• electroniccontroldevicesaredamaged
• electricfunctionsfail(indicators,brakelight,horn,ignition,lights)
INSTALLING & CONNECTING THE POWER CABLE
ThuleNVrecommendsthatyouconnectthepowercabletothefuseboxorterminalblockandnot
directlytothebattery;
Choosethesafestandshortestinstallationrouteforthepowercable.
Shortenthepowercableasrequired.
Wire in such a way, a hot exhausting pipe or something simular couldn't harm the wiring.
Caution!
Only use cable clips that are suitable for the diameter of the power cable for the connection to the fuse
box, terminal block or battery. If the wrong terminals are used, it could cause a voltage drop and increase
heat formation at the terminal.
Usethecorrectfusetotheconnectionwiththevehicle'spowersupplyaccordingthewiringdiagram and
according EN 1648-1 & EN 1648-2.
Caution!
Installingthewrongfusecancausecablefireincaseofashortcircuitormalfunction!
Ifthelengthofthesuppliedpowercableisnotsufficient,theconnectioncablemustbereplaced with a
new connection cable with a larger cable diameter.
ThuleNVisnotresponsibleforanymisprints.
Thisinstructionmaybechangedwithoutpriornotice.Wedonotacceptresponsibilityforanypossible
errors in the content
8