Publicité
Les langues disponibles
Les langues disponibles
Hyundai Coupé
1996 - 1999
Ref. 0460
Fitting instructions
1. Disassemble the bumper and the bumper supports at the back. Loosen the exhaust from the filling-up
rubbers
2. Make an incision in the bottom of the bumper of 160mmx70mm: 70 mm measured from the edge of the
bumper and 160 mm in the width of the vehicle. Make another incision in the lowest edge of the middle
the bumper support of 22mm till you reach the vertical edge.
3. Now assemble bumper at point (D)
4. Assemble bumper and tow bar via points (A), (B) and (C) of the chassis where the bumper supports
where assembled and fitting with the drillings. Also install the pieces (1) and (2) at the bottom.
Assemble the pieces (1) and (2) the points (C) fits with the screw thread hole in the side of the chassis.
Points (A) and (B) fit with the hole of pieces (1) en (2) of the points (A) and (B) of the tow bar. Fasten
with bolts.
5. Install assembly piece (3) with the side against (E) and (F) fits with point (F) of tow bar. Install (4) at the
bottom of the traction eye and do tighten everything firmly.
6. Do fix the exhaust on the tow bar
Remarque
Pour le poids de traction maximum autorisé de votre voiture, consulter votre concessionaire.
Enlever la couche de bitume ou d'anti-tremblement qui recouvre éventuellement les points de fixation.
Veiller en percant à ne pas endommager les conduites de frein et de carburant
Publicité
