Lux Tools E-VL-1800/36 Notice Originale page 24

All manuals and user guides at all-guides.com
Vertikutierer_401116.book Seite 24 Dienstag, 12. April 2016 3:19 15
GB
Personal safety equipment
Wear ear defenders
Wear safety shoes
Wear safety goggles
Wear protective gloves
Your machine at a glance
► P. 3, item 1
1. Operating lever
2. Handle bar
3. Handle bar, middle part
4. Handle bar, bottom part
5. Protective flap
6. Rotary knob for working depth adjustment
7. Bag for cuttings
8. Strain relief mechanism for extension cable
9. Operating safety lock
What is included
• Instructions for use
• Scarifier
• Handle bar
• Handle bar, middle part (2×)
• Handle bar, bottom part (2×)
• Collection sack
• Mains plug strain reliever
• Bag with small parts
Fitting
Mounting the handle
► P. 3, item 2
– Unfold the bottom parts of the handlebar as
illustrated and tighten the clamping screws (10).
– Position the middle part of the handle bar (3)
onto the bottom part of the handle bar and push
through the carriage bolts (11).
– Apply the clamping lever (12) and tighten.
► P. 4, item 3
– Push the cable grip (8) onto the handle bar (2).
– Position the handle bar (2) onto the middle part
of the handle bar and push through the carriage
bolts (13).
– Apply the clamping lever (14) and tighten.
Operation
Check before use!
DANGER! Danger of injury! Do not oper-
ate the machine unless you did not find any
faults. If a part has become defective, make
sure to replace it before you use the
machine again.
Check the safe condition of the machine:
24
– Check it for visual defects.
– Check that all parts of the machine have been
securely fitted.
Adjusting the handlebar height
► P. 3, item 2
– Undo the clamping screw (10).
– Set the handlebar to the desired height.
– Retighten the clamping screw (10).
Adjusting the working depth
Depending on the wear on the working roller, the set-
ting can be modified (working depths: ► Technical
data – p. 26).
► P. 3, item 1
– Switch the machine off.
– Raise the machine at the front.
– Adjust the desired depth of the working roller
using the rotary knob (6).
– Lower the machine again.
Attaching the cuttings bag
► P. 4, item 4
– Lift the protective flap (5) and hold.
– Slot the cuttings bag (7) into place.
– Ensure that the bag has slotted into place
securely.
Connecting the product
► P. 5, item 5
– Pull the extension cable through the cable
grip (8) as illustrated.
– Insert the extension cable coupling into the
mains.
De-thatching/aerating
DANGER! Danger of injury! Before start-
ing work, always check the ground and
remove all objects which could be thrown
by the machine.
DANGER! Danger of injury! Never release
the steering bar while working.
Note: The shorter the lawn has been cut,
the better it can be de-thatched/aerated.
► P. 5, item 6
– Position the machine on a level lawn surface.
– Press the operating safety lock (9) and hold
down.
– Pull and keep hold of the operating lever (1).
– Release the operating safety lock.
– Wait until the motor has reached its maximum
speed.
– Guide the machine at an even slow speed (walk-
ing pace) in a straight line wherever possible.