Milwaukee HBSE 75 S Instructions D'utilisation page 4

Stationary device
Setting speed of
rotation
Belt speeds and
examples for
sanding work
Switching the
machine on and
off
Advice for
operation
Dust extraction
3
ENGLISH
All manuals and user guides at all-guides.com
Screw the two feet into the threads
provided on the top side of the machine.
The straight sides of the feet should be
facing one another.
The speed is adjusted by means of the
electronic thumb wheel.
Position
Solid wood, fine 4–6
Veneer 3–5
Chipboard 5–6
Plastic 3–5
Steel 3–6
Removing varnish 3–6
Thumb wheel 1
Belt speed rpm 200 240 300 340 360 380
Intermittent use
Switching on: Press On-/off switch
Switching off: Release On-/off switch
Continuous use
Switching on: Press the On-/off switch and then the
locking button, after that release on-off switch.
Switching off: Press the On-/off switch and then release.
Always hold machine firmly with both hand prior to
switching on. Only switch on in raised position.
When sanding, guide the machine without applying special pressure. The weight of
the machine itself is quite sufficent for good sanding results.
When sanding wood, the dust bag should
be used. Place the dust with adaptor on
the suction connector and tighten the
bayonet fixing by turning to the right. The
spring of the dust bag must lie against the
metal housing.
Turn to the left to empty dust bag and
shake the dust uot by opening the
zip-fastener. the dust bag should be
emptied regularly to ensure best results.
Grit
100
100
100
100
80
24
2 3 4 5 6
2
1
HBSE 75 S