Publicité
Les langues disponibles
Les langues disponibles
the set time has elapsed, the device switches off and returns to the standby
position.
To set the hermostat with the buttons on the device, press and hold
least three seconds. You can then set the desired temperature of 18-45°C by
repeatedly touching the button. After "45" the device returns to "18".
Use the remote control to change the desired temperature using the "+" and "-"
buttons.
The desired temperature flashes a few times on the display, then the ambient
temperature is displayed again.
When the desired temperature is max. two degrees above the ambient
temperature, the device will heat at low power. If the desired temperature is
more then two degrees above the ambient temperature, then the unit will heat
at full power
Once the set temperature is reached, the device stops heating.
Note! After the thermostat has switched the heating elements off, the fan will keep
turning. This means that the air is constantly moved, allowing the heater to
accurately detect if the area is cooling down. The unit switches on again if the room
cools down to 2 °C below the set temperature.
Safeguards
Anti-tipping safeguard
The device is equipped with an anti-tipping safeguard which automatically switches
off the device if it has unexpectedly fallen. When you place it back straight, it
returns to the standby position. First switch off the device, unplug it from the
socket and check the stove for damage before putting it back into operation. In the
event of damage or malfunction, the device may no longer be operated and must
be handed over to a specialist for inspection or repair!
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater
off. This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. When the overheating safeguard
switches the heater off, set the main switch to '0' (off), unplug and allow the heater
to cool down. Remove and/or amend the cause of overheating and reuse the heater
as normal. If you cannot find a cause and overheating recurs, stop using the
heater, and take it in for inspection/repair.
Cleaning and maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning
or carrying out maintenance work.
34
for at
Publicité
