EUROM 342567 Manuel D'utilisation page 33

Assembly
1. Click together the two foot-parts A and B,
see fig. A.
2. Pass the plug and cable through the hole in
the foot and pass the cable through the slot.
3. Now click the foot on the underside of the
device, see fig. Y.
4. Firmly tighten the foot with the four screws,
as shown in fig. Z. Pass the power cable
through the cable and slot to the outside.
Location and connection
Remove all packaging material and keep out of reach of children. After

removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
Choose a suitable location for the heater which is at least one metre away from

any obstructions, walls or inflammable materials (see also safety instructions).
Make sure a functioning heater is always placed on a solid, flat and horizontal

surface.
Check that the main switch is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240V socket. To

prevent the circuit overloading, check that no other appliances are connected to
the same group.
Set-up and operation
Turn the main switch to I (on). The display shows the ambient temperature. The

device is now ready and can be operated with the buttons on the device or the
remote control. The lamps on the display indicate which functions are active.
Press ; the device starts to air. If you press again, it turns off, if necessary,

the fan cools down for another 30 seconds.
Press ; with each press, the unit switches to another function: low-power

heating – high-power heating - ventilation.
Press to allow the device to pivot. Press again to turn this feature off.

Press (device) of

presse you increase the time by half an hour up to max. 7,5 hours. The display
will flash three times the set time and then returns to the temperature. When
(remote control) to set the operating time. With each
33